Comments on: Anode Terminal For Water4Gas Electrolysis Unit http://tapwaterforgas.com/water-hybrids/anode-terminal-for-water4gas-electrolysis-unit/ All about water hybrids, water for gas, hydrogen generators, EFIEs, smacksboosters, and other sensor enhancements. Sat, 28 Aug 2010 21:26:16 +0000 hourly 1 http://wordpress.org/?v=abc By: Jim http://tapwaterforgas.com/water-hybrids/anode-terminal-for-water4gas-electrolysis-unit/comment-page-1/#comment-101 Jim Tue, 26 May 2009 00:48:40 +0000 http://tapwaterforgas.com/?p=133#comment-101 Hi John: I am struggling with screen freezes after 3-4 keystrokes at different times of the day. No one here is able to repair. So I want to send emails but only with any luck like rrightnow can I work. I average 3-4 additional MPG with a 6cycliunder Mazda B3000. I use a charged water system I haven't yet found a moderately priced camera to display pictures. When I do and can learn about it I will show the generator cooking away and charging my Tap water with gas. All the best, Jim Hi John: I am struggling with screen freezes after 3-4 keystrokes at different times of the day. No one here
is able to repair. So I want to send emails but only with any luck like rrightnow can I work. I average 3-4 additional MPG with a 6cycliunder Mazda B3000. I use a charged water system I haven’t yet found a moderately priced camera to display pictures. When I do and can learn about it I will show the generator cooking away and charging my Tap water with gas.
All the best, Jim

]]> By: John http://tapwaterforgas.com/water-hybrids/anode-terminal-for-water4gas-electrolysis-unit/comment-page-1/#comment-99 John Sun, 24 May 2009 00:55:55 +0000 http://tapwaterforgas.com/?p=133#comment-99 Jim, about your tower: I get my tower cut by a plexiglass supplier who also laser cuts the 1/4 inch spaced grooves for the wires for me. It costs me about $12.20 NZ each per unit which would be about $7.50 US. About the NITI wire you use: I have tried to source this from Fairfield Orthodontics on the water4gas site but they said they sent me some 6 weeks ago but i have not received it. I was wondering where you get yours from and if you might know of any other suppliers of NITI wire. And, incidentally, what results are you getting from your electrolyser? Thanks, John Carter, New Zealand. Jim, about your tower: I get my tower cut by a plexiglass supplier who also laser cuts the 1/4 inch spaced grooves for the wires for me. It costs me about $12.20 NZ each per unit which would be about $7.50 US.

About the NITI wire you use: I have tried to source this from Fairfield Orthodontics on the water4gas site but they said they sent me some 6 weeks ago but i have not received it. I was wondering where you get yours from and if you might know of any other suppliers of NITI wire. And, incidentally, what results are you getting from your electrolyser? Thanks, John Carter, New Zealand.

]]>