[ad#468x15] Please remember while you are watching the videos that the Water4Gas folks use a simple format in the hopes that everyone every where can find the essential elements of these generators and are able to take advantage of this technology and use it even in the poorest of countries. I’m proud to be an [...]
Here are some tips to save gasoline. First tip, please make sure that you have tuned your car to its working efficiency. To explain further, make sure that spark plugs have been changed ( if you have high miles on the car) and are working properly. Along with that make sure that all filters have [...]
Hello: Just saw a really good post on Hubpages of a Hydrogen Generator built by a non-mechanic. He added very clear pictures to each phase of his generator building. If you haven’t yet joinend Hubpages please do and check out the water gas, water hybrids areas. I will find his URL next time I am [...]
I have been working with the lighter plexiglas, the 1/8th inch thickness but alas, it just doeosn’t stand up to even the winding of the NiTi wire so today I went to Lowe’s and bought a heavier plexigas. this one is almost 1/4 and feels more sturdy. Cutting the frame wasn’t too bad. I had [...]
RunYourCarOnWater has a lot going for it with the price of the manual and the free information. The one thing that I remembered about this website was the virtual assistant talking about the program.. I don’t remember that the site had a lot of information on it. The one thing that this site had that [...]
Good Morning All. I wanted to share with you an email that I received from a Pastor in the Philippines this morning. I will do some cutting and pasting into this Post, using the Pastor’s own words. If nothing else this should tell you just how wide spread the interest is in Alternative fuels and [...]
I wanted to make sure that I added this Post before the weekend. I have been busy with my Electrolysis Unit , trying to get the windings of the NiTi wire the way I think it should be. I am using NiTi wire instead of 316L stainless steel wire because I think that the NiTi [...]
Here is some information that I received some time ago with a list of parts for that great Smackbooster. If you don’t know a lot about Smackboosters, please read through my archived Posts. I have several Posts dealing with the Smackbooster versus the Water4Gas one. I believe this from Smack himself so here it is. [...]
Continuing on with the elements of a typical Hydrogen On Demand System, lets talk about some of the other sensors. The EFIE is a common addition to the Hydrogen Booster and is an absolutely necessary addition if you do not have these other Electronic Enhancers like a MAP sensor or MAF sensor. The booster without [...]
A Hydrogen On Demand System is a case in point of the system being greater than the constituent parts, to wit, the booster, the vaporizer, the fuel heater, et al. In the next paragraphs I am going to discuss each element that goes into the hydrogen on demand system. It is my aim to show [...]
 |  |  |  |  |  |  |  |  |
 |  |  |  |  |  |  |  |  |
 |  |  |  |  | ||||
The oxygen sensor "tells" the computer what the oxygen content is by providing a voltage on it's signal wire between 0 and 1 volt. 450 millivolts (.45 volts) means that the fuel/air mixture is correct. Higher values means the mix is rich (has too much gas), and lower voltages means the mix is lean. By adding voltage to the sensor's output, we can compensate for the additional oxygen in the exhaust.